tp link av200 nano powerline adapter utility download

Click Next to continue the installation.

If the CD is lost or misplaced, you can download the latest software utility for the adapter from. From the computer directly connected by Ethernet cable to the XAVN2001 adapter, run the CD.Wireless LED - indicates that the XAVN2001 wireless radio is on Powerline LED - shows that the two Powerline devices are linkedĮthernet LED - shows that the Powerline device is communicating with your network Do not proceed with the installation until the following LEDs show as a steady green:.Physically connect the Powerline adapters as shown below.

Thus some 'tips' for anyone else aiming to extend their existing PLC system:ġ) select a unit from the SAME 'generation' (thus '8th', '9th2, or 'whichever'!).Ģ) then select a unit of EXACTLY the same type/model number - Otherwise, be prepared for 'a lot of problems', and 'many' 'return to sender, not working' 'experiences' :(Įdited a month later: I think that the reason that many have found these units to 'stop working after a few minutes' is because they default to 'Powersave' mode after around 10 minutes - thus download and install TP-Link's tpPLC.This article provides walk-through instructions for installing an XAVN2001 Powerline wireless extender, however the information within may be applicable to other Powerline wireless extenders.

WEEEEE!! - after trying MANY other 8th & 9th generation units (none of which worked reliably for more than a few minutes!), Finally, THIS one seems to have worked pretty well for the last few days (and still is). Verified purchase: Yes | Condition: RefurbishedĮxtending your PLC network? - be very careful exactly which unit you choose! I do have to mention they are much much larger than the AV200 set they replaced. With 8 people in the house with a mix of phones laptops and tablets the PLAs have so far handled traffic really well. The the built in 3 port gigabit switch allowed me to connect a dedicated wifi AC access point and bypass the poor wifi from the Sky router. Replacing them with the AV1200 set I got the full 76mb coming into the router. This year I upgraded to Sky 80mb fibre and found the AV200 couldn't achieve more than 50-55mb. The AV200 set still managed to give me the full 40mb connection with no signal loss. A year later I upgraded to Sky fibre with a 40mb connection. At the time my internet connection was only 17mb and I managed to get the full 17mb through the AV200 set. I needed a wired connection to my PC which was on the first floor. Wifi signal is very poor and being in an area with surrounding flats the 2.4ghz wifi channel was very congested. I live in a 2 floor house and the Sky provided SR102 wifi router is downstairs. I purchased the TP-Link AV1200 PLA set to replace an existing TP-Link AV200 set that I've been using for around 3 years. Good as an ethernet cable direct to your router

Tp link av200 nano powerline adapter utility download